How to Clean a Vacuum Filter (Washable and Not)
A clogged filter is one of the most common reasons a vacuum loses suction. Dust builds up in the filter...
A clogged filter is one of the most common reasons a vacuum loses suction. Dust builds up in the filter media, airflow drops, and the motor works harder. Cleaning the filter on a schedule keeps suction steady and can help the motor last. This guide covers the main filter types and how to care for each, but your vacuum’s manual always comes first.
Before you start: Unplug corded vacuums, and remove or switch off the battery on cordless models. Check your manual to see which filters are washable. Some filters, including many HEPA and paper filters, must never get wet, and washing them can ruin them.
Find Your Filters
Most vacuums have more than one filter:
- Pre-motor filter: protects the motor from fine dust. Often foam or felt, and often washable.
- Post-motor or exhaust filter: cleans the air leaving the vacuum. Often a pleated or HEPA-type filter.
- Bag: on bagged vacuums, the bag is the main filter.
- Cyclone or shroud: on bagless models, a mesh screen inside the bin that collects hair and lint.
How to Clean a Washable Filter
- Remove the filter as the manual shows.
- Tap off loose dust into a trash can, outdoors if you can.
- Rinse with cold water only, unless the manual says otherwise. Do not use soap or detergent unless the maker allows it.
- Squeeze or shake gently until the water runs clear. Do not wring or twist pleated filters.
- Dry completely at room temperature for the time the manual gives. Do not use a hair dryer, oven, or dryer.
- Reinstall only when fully dry. A damp filter can grow mildew and can damage the motor.
How to Clean a Non-Washable Filter
- Tap it out: knock it gently against the inside of a trash can.
- Brush it lightly: use a soft, dry brush on the dirty side only.
- Replace it on schedule: many makers list a replacement interval. Replace sooner if it is torn or stays dark after tapping.
Clean the Rest of the Airflow Path
- Bin and cyclone: empty the bin and clear hair from the mesh screen. Some bins are washable; dry them fully.
- Hose and wand: check for clogs by looking through them or dropping a coin through the hose.
- Brushroll: hair wrapped around it reduces pickup. See our guide to cleaning a vacuum brushroll.
How Often to Clean Filters
Follow your manual first. As a general rule, check filters more often if you have pets, vacuum fine dust or sand, or use the vacuum daily. A drop in suction, a dusty smell, or the motor sounding strained are signs a filter needs attention.
FAQ
Can I wash a HEPA filter?
Only if the maker says it is washable. Many HEPA filters are not, and water can damage them.
Why does my vacuum smell after cleaning the filter?
It was likely put back damp. Remove it and let it dry fully before using the vacuum again.
Can I use the vacuum without a filter while it dries?
No. Running without a filter can pull dust into the motor and damage it. Many owners keep a spare filter.
